Descargar Imprimir esta página

Kit Assembly - Metra 95-6523 Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Attach the (4) panels clips to the radio
trim panel. (Figure A)
2. Break the small locating pin
from inside surface of each
radio bracket. (Figure B)
3. Position the radio mounting brackets
into the sub dash opening and secure
with the (2) Phillips screws removed in
disassembly. (Figure C)
(Figure A)

KIT ASSEMBLY

Remove pin
(Figure B)
(Figure C)
4. Attach the radio brackets to the
aftermarket radio using the screws
supplied with the radio or the supplied
(8) Phillips screws.
Note: Screws must not protrude from
slot in radio brackets as interference
with mounting bracket will occur when
sliding radio into mounting brackets.
(Figure D)
5. Locate the factory wiring harness in
the dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative battery
terminal and test the unit for proper
operation.
6. Slide the aftermarket radio into the
radio opening between the radio
mounting brackets until it clips into the
opening. (Figure E)
7. Snap the radio trim panel into
the opening around the aftermarket
radio to complete the installation.
(Figure D)
(Figure E)
REV. 3/16/2018 INST95-6523
3

Publicidad

loading