QUICK REFERENCE GUIDE: KI7300C / 7700C SERIES OPTICAL LOSS TEST SET
MANUAL OPERATION
•
To remove interchangeable connector adaptor, press button on rear of case
and pull off adaptor. This may be easier with a test lead attached.
•
To defeat auto power-off, hold [POWER] for 3 seconds at turn on until 'ON'
and 'Perm' are displayed.
•
Low battery is indicated with a battery symbol.
POWER METER MODE:
•
To enter, press [POWER METER].
•
To select operational wavelength, press [-/+].
•
To set reference, press [ABS/REL] and hold [SET REF] for 3 seconds. Meter
displays about 0.00 dB R.
•
To stop / start display update, press [HOLD].
•
If a test tone is detected, meter will display 'Hz'.
•
To toggle log / linear display mode, press [dB/W].
•
To display minimum and maximum recorded power for selected wavelength,
press [
] and [Max/Min]. Press [
re-start recording.
] [Max/Min] and hold for 3 seconds to
LIGHT SOURCE MODE:
•
To enable source, select [Source].
•
To change wavelength, press [-/+].
•
To activate modulation, press [Mod].
•
To change modulation frequency, while source is active press [
•
[-/+] [Set] or [Menu].
•
To change laser power level, while source is active press [
[Set] or [Menu].
AUTOTEST OPERATION
•
To initiate Autotest, connect Power Meter section to Light Source section and
press [Autotest].
•
To show one wavelength only, scroll [-/+]. Press [Menu] to exit.
•
Press [Hold] to hold / resume display update.
•
Autotest remains for 8 seconds after signal loss, to allow quick connection
change.
•
To exit Autotest, remove test lead for >8 seconds, or on the Light Source,
press [MENU].
English
] [KHz]
] [Level] [-/+]
23