Truth Or Myth - GE Serie Manual Del Propietario E Instrucciones De Instalación

Before you call for service, review the detailed troubleshooting tips in the Owner's
SERVICE
manual. If needed, service can be scheduled by visiting us online GEAppliances.
com or calling 800.ge.CARES 800.432.2737

Truth or Myth

Truth or Myth?
The refrigerator water filter may require replacement
prior to six months
The automatic ice maker in my refrigerator will
produce ice when the refrigerator is plugged in to a
power receptacle.
After the refrigerator has been plugged in and
connected to water, I will immediately have unlimited
chilled water available from the water dispenser.
After water dispenses, a few drops of water are
normal.
I will never see frost inside the freezer compartment.
When the refrigerator is installed, or after replac-
ing the water filter, I must dispense water for five
minutes.
To fill the ice bucket to the maximum capacity, I
should dispense 12 and 18 hours after installation.
I can use the water filter bypass plug to determine if
the filter requires replacement.
The top of the refrigerator doors will always be
aligned.
Refrigerator door handles can be easily tightened.
There may be odor and taste problems with your ice.
I can make fine adjustments to the fresh food doors
to align them.
Door handles should always be removed for
installation.
*Some models do not come equipped with the filter bypass plug. To obtain a free bypass plug, call 800-GECARES.
In Canada call 800.561.3344.
Answer Explanation
TRUE The water filter indicator will indicate the need to replace the water
filter every six months or 170 gallons of water dispensed (select models
only). Water quality varies from city to city. If water flow from the
dispenser slows, or ice production decreases, the water filter should be
replaced, even though the filter indicator may not indicate the need for
replacement.
MYTH The refrigerator must be connected to water, and the ice maker must be
turned on. Make sure the ice maker is turned on, only after the water line
is connected and water is turned on. The ice maker can be turned on/
off from the controls and ensure the ice maker is on, as indicated on the
refrigerator control panel. See About the Automatic Ice Maker.
MYTH The water dispenser tank located inside the refrigerator stores water
for dispensing. The water in this tank requires 24 hours to chill after
installation. High usage conditions will not allow time for the water to
chill.
TRUE A few drops of water may fall from the dispenser, after the dispenser
paddle has been released. To minimize the drops, remove the glass
slowly from the dispenser.
MYTH Frost inside the freezer typically indicates that the door is not properly
sealed, or has been left open. If frost is found, clear the frost using a
plastic spatula and towel, then check to ensure that no food packages
or containers are preventing the freezer door from closing. Check the
refrigerator control panel to ensure the door alarm is on.
TRUE A newly installed refrigerator or water filter contains air in the water lines.
Press the dispenser paddle and dispense cold water for at least 5 minutes
to remove air from the water line, and flush the filter.
TRUE Dispensing 3-4 cubes 12 hours and 18 hours after installation, allows ice
to disperse within the ice bucket, which in turns calls on the ice maker to
produce additional ice. Normal ice production = 100 cubes in 24 hours.
TRUE Decrease in flow from the water dispenser, or decreased ice production,
may indicate the need to replace the water filter. Install the water filter
bypass plug (provided with the refrigerator on some models*), and check
flow from the dispenser. If water flow returns to normal with the bypass
plug in place, replace the water filter.
MYTH Several things can affect the fresh food door alignment, including the
floor the refrigerator is installed on and loading of doors. If the top of the
fresh food doors are not aligned, use a 1/4" allen wrench to adjust the
right/left hand door. The adjustment screw is located on the bottom right
or left hand side of the door; open the freezer door to access the screw.
TRUE If door handles are loose or have a gap, the handle can be adjusted using
a 1/8" allen wrench, on set screws located on the ends of the handles.
TRUE After starting the ice maker throw away 24 hours of ice production to
avoid odor and taste problems.
TRUE If the fresh food doors are not aligned, use a 1/4" Allen wrench to adjust
the right hand door. The adjustment screw is located on the bottom of the
right/left hand door. Open the freezer door to access.
MYTH Check chart on reverse side of this instruction. If the doors must be
removed do not remove the handles, or if the refrigerator will fit easily
through the passage way opening. Adjust handles that are loose or have
a gap, by adjusting 1/8" set screws on either end of handles.
41