Surface Screen (Post-Dive) - Cressi DIGI 2 Manual De Instrucciones

 WARNING!
Cressi Sub S.p.A. strongly recommends that you
consult the data provided by the DIGI 2 console frequently during
your dive. Conditions such as temperature, any physical exertion
greater than a standard dive, or dives when under significant
emotional stress can significantly vary air consumption, and divers
can only prevent potential problems by carefully and frequently
checking this information.
 WARNING!
When the "replace" low battery warning appears,
replace it with a new one.
P80-DIGI 2.indb 29

SURFACE SCREEN (POST-DIVE)

When the dive is complete, two minutes after reaching the surface
(depth < 0.8 m), the DIGI 2 console switches back to surface mode
(see chapter SURFACE SCREEN [PRE-DIVE]). Thus it will show the
following information:
1. CURRENT CYLINDER PRESSURE (set in BAR or PSI)
2. CURRENT DEPTH (set in m or ft)
3. MAXIMUM DEPTH reached in the previous dive (set in m or ft).
EN
29
1 second
5 seconds
13/06/19 14:01