Airzone Lite Thermostats; Lite Thermostat Reset - Airzone ACUAZONE IBPRO32 Guía De Instalación Rápida

AIRZONE LITE THERMOSTATS

To configure a Lite thermostat, follow these steps:
Wired Lite thermostat
ES
- Perform all the appropriate connections.
- Connect the thermostat.
EN
- Press the LED
- The number of the zone which associates with the thermostat is the lowest free available number.
FR
- If the association is correct, the LED
IT
Wireless Lite thermostat
- Open the wireless association channel of the main board, wait a few seconds so the control module, which will be
PT
associated to the thermostat, opens its wireless association channel (the wireless opening LED must be solid red).
- Insert the battery to supply the thermostat.
DE
- Press the LED
IMPORTANT: The thermostat will display first the wireless control modules which are closer to it. Remember to
configure this thermostat near the wireless control module to associate for greater comfort.
- The module which will be associated to the Lite thermostat will begin to make a "beep" for its identification. The LEDS
will show the signal level of this module:
o
o
o
o
- Press the LED
- The number of the zone which associates with the thermostat is the lowest free available number.
- If the association is correct, the LED
range.
REMEMBER: It is required to set the Main ID parameter of the Lite Controller for its proper functioning (see section Advanced
settings – Blueface controller, Zone settings).
Configure other functionalities of the LITE thermostat from the advanced configuration menu of a Blueface thermostat (see
section Advanced settings, Zone settings) or Webserver Cloud (See Webserver Cloud installation manual).
IMPORTANT: For changing the zone address, access the parameter Zone Address, inside the advanced settings menu from a
Blueface thermostat (see section Advanced settings, Zone settings).

Lite thermostat reset

To reset to factory values of any Lite thermostat, turn up the microswitch 8 and place the thermostat on the base again. Press
on , the LED will flash green twice when the reset process is completed.
To reassociate it, lower the microswitch 8, place the controller on its base and follow the steps displayed in the Initial setup
section, on Lite Controllers.
36
to confirm the association.
will flash green 5 times.
to begin the wireless search. The LED
Low signal range level (It is not recommended to perform the association).
Medium signal range level.
Good signal range level
Excellent signal range level.
to confirm the association, otherwise use
will flash green 5 times. If it flashes red twice, it means the thermostat is out of
will blink in green.
to select another module.