Techno Line WS8013 Manual Del Usuario página 10

the desired value more quickly
Alarm Function:
Press the "MODE" button (B1) to view alarm time, "ALARM TIME" flashes on the display

While viewing the alarm time, press the "MODE" button (B1) for 3 seconds to enter alarm

time setting, the alarm hour is flashing.
Press the "+" (B4) or the "-" (B5) button to set the alarm hour.

Press the "MODE" button (B1) to confirm the changes and the alarm minute is flashing.

Press the "+" (B4) or the "-" (B5) button to set the alarm minute.

Press the "MODE" button (B1) to confirm the setting and return to time display mode.

Note:
 All setting modes will automatically exit in 15 seconds without any adjustment
By keeping the "+" (B4) or "-" (B5) button pressed, will accelerate the process and reach

the desired value more quickly
Snooze Alarm Function:
Press the "ALARM" button (B3) to activate or deactivate the alarm. If the alarm is on,

alarm icon " " appears on the display.
Press the "SNOOZE" (B2) button while the alarm sounds. The alarm snoozes for around

5 minutes, then it alerts again. "
process can be repeated for 7 times.
Press any buttons except the "SNOOZE" button to stop snooze alarm. Otherwise, base

on the previous setting of alarm sound duration, the alarm alerts for 2 minutes or 1 minute,
then stops automatically.
Thermometer
 If the temperature is out of the measurable range, LL.L (beyond the minimum temperature)
or HH.H (beyond the maximum temperature) will be shown on the LCD.
 If the humidity is lower than 20%,
it's higher than 99%.
Hereby, Technotrade declares that this product WS 8013 is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU and ROHS 2011/65/EC.
The original EU declaration of conformity may be found at:
www.technoline.de/doc/4029665080130
" flashes on the LCD during the snooze time. This
will be shown on the LCD and display 99% when
EN04