3M Peltor Tarctical XP Manual De Instrucciones página 8

EN
TECHNICAL DATA (D)
(D:1) Attenuation values, SNR
The attenuation values and noise levels for the hearing protector have been tested and approved according to EN 352-4 2001, EN 352-3
2002, EN 352-6 2002 and EN 352-1 2002. Certificate issued by FIOH (Registered Number 0403), Laajaniityntie 1, FIN-01620 Vantaa, Finland.
1. Frequency. 2. Average attenuation. 3. Standard deviation. 4. Expected attenuation
(D:2) Sound exposure when using the auxilary input
1. Level under the ear-muff [dB(A)]
2. Input voltage [mVrms]
A. External volume normal, mode 1
B. External volume normal, mode 2
C. External volume normal, mode 3
D. External volume high, mode 1
E. External volume high, mode 2
F. External volume high, mode 3
G. Power off (failsafe mode)
(D:3) Criterion level
The criterion level is the noise (mesured as A-weighted sound pressure level) outside the hearing protector that gives 85 dB(A) inside. The
outside level depends on the type of noise: H is high – frequency dominated noise, M is noise that is not dominated by any given frequency and
L is low – frequencydominated noise.
FITTING/ADJUSTMENT(E)
Adjusting the helmet attachment
(E:1) Snap the helmet attachment into the slot on the helmet. To switch the unit from ventilation to working position, press the headband wires
inwards until you hear a click on both sides. Ensure that the shell and the headband wires in working mode do not bump or snag on anything
so that noise leakage can occur.
Note: The shells can be set in three positions: (C:2) working position, (E:3) ventilation position and (E:4) parking position.
Adjusting the neckband
(E:5) Adjust the shells so the ears are completely surrounded by the ear cushions.
(E:6) Adjust the height using the headband until you have a snug, comfortable fit.
(E:7) The headband should lie across the top of the head.
Adjusting the headband
(E:8) Open the headband.
(E:9) Tilt the top of the shell out, as the wire must be placed on the outside of the headband. Slide out the shells and place the hearing protectors
over your ears so the ear cushions enclose the ears completely and fit snugly against the head.
(E:10) Adjust the height of the shells for a comfortable fit while holding the headband flat against your head.
(E:11) The headband should lie across the top of the head.
IMPORTANT! For the best protection, brush aside hair around the ears so the ear cushions fit snugly against the head. Spectacle frames should
be as thin as possible and fit close to the head.
INSTRUCTIONS FOR USE
Switching On and Off
Press the centre/mode button and hold for at least 2 seconds.
Increase/Decrease the volume of the level dependent function
Press the upper (+) button to increase. Press the lower (-) button to decrease.
Adjusting the balance
Press the mode button until the ghost voice says balance. Adjust the balance, to the right or to left, by using the (+) button and (-) button. Press
the (+) button and (-) button at the same time.
to reach centre balance.
Equalizer
Press the mode button until ghost voice says equalizer. Use the (+) button and (-) button to adjust the equalizer. Available settings are: Low,
Neutral, High and Extra High.
8