Port Pair Alignment - Renishaw ACR2 Guia De Instalacion

INSTALLATION

2.2 Port pair alignment

ALIGN FRONT FACE
TO WITHIN 0.5MM
THIS DIRECTION
22
1. Mount a pair of ports to the mounting fixture using four off M8 bolts
through the mounting holes shown in Figure 2.
2. Align the port mounting plate, with the use of shims if necessary, such
that the front face is aligned to the machine axes within ±0.1° (0.5mm
runout) and the runout on the top face is within 0.5mm.
Two off M8 screws (supplied in the port pair kit) can be used in the
adjustment holes (see Figure 2) to assist in aligning the port pair.
FACE B : ALIGN TO WITHIN 0.5MM
FRONT FACE
ALIGN TO
WITHIN ±0.1°
ALIGN FRONT FACE TO WITHIN 0.5MM THIS DIRECTION
Figure 3 – Port pair alignment
Manual No. H-1000-4045