Care And Maintenance - ROMPA 18549 Manual De Instrucciones

The tongued wall will rise as it is inserted and then drop level with the slotted wall
when they fully engage. Keep the angle of the straight walls at a 90° angle.
5. The curved wall can now be attached to the two straight walls.
6. Carefully lower the floor into the walls, taking care to ensure that the mains lead
(and transformer) extend away from the raised floor towards the wall socket.
Ensure the mains lead and speaker cable pass through the groove in one of the walls.
7. Fit the isolating transformer to the room wall near the mains supply (wall socket).
8. Plug in and switch on. Make sure the floor is lighting up, and changing colour.
9. Pour in the balls. This ballpool will require approximately 3 boxes of 7.5cm balls. We
recommend the use of clear balls so as to be able to see the coloured lights most
effectively.

14. Care and Maintenance

 The LED lights in the Vibro Tub should give 10,000 hours of trouble-free lighting with
no bulbs to change.
 For indoor use only.
 Always supervise the use of these products.
Fabric Care
 Organise a regular cleaning schedule.
 Vinyl will crack, tear and rub off if subjected to sharp objects or continual rubbing by
hard objects. Remove shoes, and avoid buckles, zips or sharp/hard/pointed objects
coming into contact with the surface.
 Check seams regularly to ensure that these are not worn or split and the interior
filling cannot be accessed. Do not attempt to access the interior part of this product.
Never allow children or vulnerable people to access the interior part of this product.
 Wipe off accidental marks/liquids at the time they occur or are noticed.
 From time to time, if possible, lift products to clean all surfaces and the floor underneath.
 Our Soft Play products are intended to provide comfort and relaxation. Avoid eating
and drinking whilst using these products.
 Steam cleaning is not advised.
 Do not place near sources of heat or fire that may damage the surface (radiators,
fires, underfloor heating, hot central heating pipes etc.)
 Direct contact with bright sunlight may affect material over time.
 Do not saturate the material with lots of water.
PVC (Vinyl)
 Use a soft brush remove all loose dust/dirt
 Clean with a mild detergent (such as Lux soap flakes in luke-warm solution) applied
to a sponge or damp cloth. Do not use an abrasive cleaning pad.
 This may be sanitised using a weak solution of Milton fluid.
 Do not use excessive amounts of water and always ensure the PVC is dry after cleaning.
 Do not use boiling/very hot water, washing up liquid / aggressive detergent or
solvent based cleaner as this will cause the coating to discolour and go hard.
 Steam cleaning is not advised.