EN
DESCRIPTION
Enclosed hose reel for air, cold & hot water, oil lubricants, grease, and other fluids depending on model.
Hose can be extended to the desired length and latched with the mechanism.
By pulling the hose, the latch is released and the hose is automatically rewound by means of a power spring.
WARNING
!
• This equipment is for professional use only.
• Do not allow the hose to recoil unattended.
• Ensure that pressure does not exceed maximum working pressure or temperature rating of lowest rated system component.
• Use fluids and solvents that are compatible with the equipments wetted parts.
• Release pressure inside the reel before servicing.
• Use protective guards or covers during use or maintenance.
• Fluids under pressure can cause serious injury.
• Do not alter or modify equipment.
• Keep clear of moving parts.
• The power spring is always under great tension. To reduce the risk of serious injury, do not attempt to replace or service the spring.
• To avoid damage the power spring, never exceed the maximum power spring turns, which are specified in this handbook.
INSTALLATION
Hose reel can be installed directly onto a fixed surface or using a plate
(fig. A) or a pivoting bracket (fig. B). Be sure the mounting surface is
strong enough to support the weight of the reel, the fluid, and the stress
caused by pulls on the service hoses.
Several mounting positons are available to match the users needs. For a
proper and smooth operation, avoid the hose to bend with sharp radius
or angles. Hereafter you can see the recommended and most common
mounting positions:
FLOOR
1. To take in place the hose reel, first assemble the base (1) (fig. 2) on
the desired hose reel flank. Then, use the sheet metal screws (2)
(fig. 2) to attach the base to the casing. Is possible to attach the base
in 3 different positions (fig. 2).
2
850 840 R. 09/19
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
Fig. A
WALL
2
1
Fig. B
CEILING
Fig. 2