Samoa RM-12CLX Serie Guía De Servicio Técnico Y Recambio página 3

INSTALLATION
2. To suspend the hose reel on the mounting surface (2) (fig. 3), it is
recommended first to introduce in it two M10 bolts (1) (fig. 3), with
their heads slightly jutting out. Over this bolt heads, the reel can be
suspended.
HOSE INSTALLATION
FIRST HOSE INSTALLATION:
1. For the first hose installation, be sure to securely anchor the hose reel
on a flat and stable surface. The power spring must be relaxed, in
such a way that the spool does not try to turn while the ratchet is
unlocked.
DANGER!
!
Handle the hose reel with care, wearing heavy leather gloves &
the appropriate sucurity elements. While turning the spool, the
power spring will gain force and speed, specially if the spool
starts to turn freely. Grab the spool firmly to avoid it to turn
freely, thus in this case, it could cause injuries. Keep clear of
moving parts during operation.
2. Place the hose stopper at the hose outlet end (fig. 5).
3. Take away the bolts (1) (fig. 6) which are used to hold the spring
fixation. Doing this, the spring fixation will be free to rotate,
avoiding the spring of getting tension.
4. Disassemble the service lid (1) (fig. 7) loosening the plastic nuts (2)
(fig. 7). Tools are not required to loosen this nuts.
5. Introduce the hose end (the opposite one of the hose stopper)
through the rollers outlet (3) (fig. 7), and put it through the spool
window, to be able to conect it to the hose reel fitting (4) (fig. 7).
The casing has a wide window to facilitate the task. When tightening
the fittings, beware not to place too much stress over the plastic
spool, because it could be damaged.
6. Once the hose is connected to the fitting (4) (fig. 7), introduce
an Allen key (7 mm between faces) inside the brass hexagon (2)
(fig. 8), and turn this key to turn the spool in possitive direction,
following the indication stamped on the casing (4) (fig. 8). In this
way, step by step, the hose will be coiled and the power spring
will not get tension. When the hose stopper touches the rollers
(3) (fig. 7), stop turning the spool.
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
3. Once the reel is suspended, always holding it securely, proceed to
2
1
Fig. 3
2
introduce the remaining two bolts (3) (fig. 4), which should be no
longer than 10mm to be able to screw them easily.
3
1
5
4
EN
Fig. 4
Fig. 5
Fig. 6
1
3
Fig. 7
R. 09/19 850 840 3