Panasonic R410A Instrucciones De Instalación página 19

4-3. Wiring System Diagrams
Power supply
220/230/240V ~50Hz
Ground
Remote
controller
Power supply
220/230/240V ~50Hz
Ground
Remote
controller
NOTE
(1) Refer to Section 4-2. "Recommended Wire Length and Wire
Diameter for Power Supply System" for the explanation of
"A", "B", "C", "D" and "E" in the above diagram.
(2) The basic connection diagram of the indoor unit shows the
terminal boards, so the terminal boards in your equipment may
differ from the diagram. (Fig. 4-2)
(3) Refrigerant Circuit (R.C.) address should be set before turning
the power on.
(4) Regarding R.C. address setting, refer to the installation
instructions supplied with the remote controller unit (Optional).
Auto address setting can be executed by remote controller
automatically. Refer to the installation instructions supplied with
the remote controller unit (optional).
Indoor unit
(No.1)
Ground
Indoor unit
(No.1)
Ground
19
* 3-phase model connections
Outdoor unit (3-phase)
INV unit
* Single-phase model connections
Outdoor unit (single-phase)
INV unit
6P terminal board
R1 R2 U1 U2 L
Remote
Unit
controller
control
line
wiring
Shielded
wire ground
N1 Type
Power supply
380 – 415 V, 3 N~ 50Hz
Ground
Power supply
220 – 240 V ~50Hz
Ground
Fig. 4-1
N
Earth
Power
suppy
Fig. 4-2