Horizon Global 76074 Instrucciones De Instalación página 4

1. Lower muffler – Lower muffler by removing the (2) rearmost rubber
hangers. Note: A spray a lubricant on rubber hangers makes them
slide off metal pins more easily. NOTE: Be careful that exhaust is
supported before removing rubber hangers.
3. Raise hitch into position – raise the hitch over the tailpipe(s) and
align holes in hitch with existing weldnuts in frame rail.
©2016, 2018 Horizon Global™ Corp - Printed in Mexico
2. Remove underbody appearance panels (if present) – remove (2)
plastic underbody appearance panels, (1) each side, located under
the rear bumper and behind the rear wheels. Using a standard
screwdriver, remove the plastic push rivets from each panel and pull
down to remove the panels from plastic push nuts. Set aside for
reinstallation later.
4. Install fasteners - Install (7) M10 bolts and conical toothed washers
as shown in figure 1.
Sheet 4 of 15 76074NP 4-3-18 Rev. B