Adjusting The Anti-Spatter Fluid En - Abicor Binzel TCS Compact Manual De Instrucciones

6 Putting into operation
6.3.1 Adjusting the anti-spatter fluid
1
9
8
1 Welding torch
2
Rubber seal for the gas nozzle
3 Gas nozzle
Fig. 14
Adjusting the anti-spatter fluid
NOTICE
• Ensure that the welding torch/gas nozzle is positioned concentrically over the injection unit.
1 Move the welding torch (1) over the injection opening.
2 Move the welding torch (1) slowly downward (in the direction of the arrow). This 'opens' the rubber seal (2).
The welding torch's immersion depth is limited by the injection unit's stroke.
3 Move the front side of the gas nozzle (3) against the thrust ring (4).
Move the welding torch (1) further down to activate the injection pulse.
NOTICE
• Note the max. stroke of the injection unit.
 Fig. 15 Injection unit stroke movement on page EN-23
EN - 22
Deactivate injection pulse
2
Max. 6 mm
Activate injection pulse
4 Thrust ring
5
Injection nozzle
6 Return flow bottle
3 2
7 Anti-spatter fluid bottle (full)
8
Adjusting screw (anti-spatter fluid volume control)
9 Cover
BAL.0617.0 • 2021-05-20
TCS Compact
4
5
6
7