Reset Av Settings; Software Upgrade; Connect Accessory Devices; Set Top Box To Tv - Philips 26PFL5302D/37 Manual Del Usuario

Connect Accessory Devices

1a

Set Top Box to TV

1
2
HDMI 2
AUDIO OUT
(DIGITAL)
1b
Set-Top Box to TV
Source Button
3
1
AUDIO OUT
(DIGITAL)
Next Source
TV
AV 1
AV 2
HDMI 1
HDMI 2
Side
2
CABLE / ANTENNA
HDMI 1
Next Source
TV
AV 1
AV 2
HDMI 1
HDMI 2
Side
2
CABLE / ANTENNA
HDMI 2 HDMI 1

Reset AV settings

This function allows you to reset most of the picture and sound settings to
their predefined factory states.
& Select
with the cursor down.
Reset AV settings
é Press the cursor right.
" Press the
button to erase settings and reset them to their default
OK
values.

Software upgrade

This menu allows you to upgrade your TV software by using a USB
device.
USB upgrade
It is possible to initiate an upgrade procedure from a USB portable
memory. The memory device must be filled with the appropriate
upgrade image (and structure) which can be found on the www.philips.
com/welcome website.
Using HDMI
& Connect the RF cable from the wall to the back of the cable box.
Set the set-top box to CH 3 or 4 and tune the TV to the same channel.
In some cases, the cable box will automatically tune to channel 3 or 4. Just
change channels until the picture appears.
é Connect the cable box to the TV by using the HDMI cable.
Note : If the accessory device has DVI output only, use a DVI to HDMI adapter
cable to connect to the HDMI connector. You need to also connect the audio
cable to L and R AUDIO jacks. Next, go to Menu => TV menu =>
Installation => Connections => Audio in L/R => AV1.
Using RF Cable
& Connect the RF cable from the wall to the back of the cable box.
2 Use a second RF cable to connect the cable box to the TV's antenna
input.
This connection gives mono sound. For stereo sound use also composite audio/
video connection (Refer to panel 3).
Using Component Video Input
& Connect the Component Video and Audio cable to the back of the cable
box accordingly.
é Connect the red and white audio cables from the cable box into the
audio AV inputs of the TV.
" Press the Source button on the remote control until the connected
source AV 1 appears on the TV screen.
21