Use Limitations; Maintenance, Storage And Transport; Environmental Protection - Alpina AS 46 P Traducción Del Manual Original

parts stop, and carefully inspect the machine
to check there is no damage. Vibrations are
normally synonymous with a problem. Repair
any damage before re-using the machine.
• Before leaving the machine, disconnect all the
commands and remove the ignition key from its
slot on the machine.
• Before carrying
inspections or adjustments, switch off the
engine, remove the key and wait the moving
parts stop (unless otherwise indicated in the
instructions). Disconnect the cable on electric
motors. (Optional).
• Do not touch the engine parts which heat up
during use. Burns hazard.
• Never operate the snow thrower at high
transport speeds on slippery surfaces. Use
care when reversing. Look behind you to make
sure there are no obstacles before and during
operations in reverse gear.
• Disengage power to the auger when snow
thrower is transported or not in use.
• Always be sure of your footing, and keep a firm
hold on the handle. Walk never run.

Use limitations

• Do not use the machine sideways on a slope.
Always move from top to bottom, then from
bottom to top. Exercise caution when changing
direction on a slope. Avoid steep slopes.
• Do not use the machine if the guards are
insufficient or if the safety devices are not
correctly positioned.
• Never disengage or tamper with the safety
systems.
• Do not alter the engine adjustments, nor over-
run it. If the engine is forced to work with an
excessive number of rotations, the risk of
personal injury increases.
• Do not overload the machine by driving it too fast.
• Do not place hands inside the chute or the
auger without firstly switching off the engine and
removing the key.
2.4 MAINTENANCE,
TRANSPORT
Ensure regular maintenance and correct storage
to maintain machine safety.
Faulty or worn-out parts must always be
replaced and never repaired. Only use original
spare parts: the use of non-original and/
or incorrectly fitted parts will compromise
the safety of the machine, may cause
accidents or personal injuries for which the
Manufacturer is under no circumstance liable
or responsible.
out repairs, cleaning,
STORAGE
Maintenance
• If the fuel tank has to be drained, this should be
done outdoors and when the engine is cool.
• To reduce the risk of fire, regularly check the
machine for oil and/or fuel leaks.
Storage
• Do not leave fuel in the tank if the machine is
stored in a building where fuel vapours come
in contact with the open flame, sparks or heat
sources.
• Let the engine cool down before storing the
snow thrower indoors.
• Always refer to owner's guide instructions for
important details if the snow thrower is to be
stored for an extended period.
Transport
• If the machine must be transported on a truck or
trailer, use ramps with suitable resistance, width
and length.
• Load the machine with the engine switched off
and pushed by an adequate number of people.
• During transport, close the fuel cock (if there is
one) and adequately secure the machine to the
means of transport using cables or chains.

2.5 ENVIRONMENTAL PROTECTION

Safeguarding the environment must be a relevant
and priority aspect of machine use, of benefit to
the community and the environment we live in.
• Avoid being a disturbance to the neighbourhood.
• Adhere strictly to the local regulations governing
the disposal of packaging, oil, fuel, filters,
damaged parts or any other element which may
have an impact on the environment; this waste
should not be disposed of along with standard
household waste, but must be disposed of
separately and sent to special waste disposal
facilities for handling and recycling.
• When the machine is withdrawn from service,
do not dump it in the environment, but take it to
a waste disposal facility in accordance with the
AND local regulations in force.
EN - 3