Main Components; Assembly Components; Handle Assembly; Discharge Chute Assembly - Alpina AS 46 P Traducción Del Manual Original

Write the identification data of the machine in the
specific space on the label on the back of the
cover page.
IMPORTANT Use the identification names on
the identification label of the product.
IMPORTANT Use these means of identification
whenever you contact an authorized service
workshop.
IMPORTANT The example of the
declaration of conformity can be found
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is made up of the following main
components (fig. 1 ) :
A. Handle
B. Auger control
C. Auger command cable
D. Handle for manual start
E. Handle closure screws
F. Lower part of handle
G. Power plug
H. Machine casing
Fuel plug
I.
J. Exhaust chute
K. Deflector
L. Auger
M. Auger safety guard
N. Wheel
O. Lower blade
P. Chute adjustment handle
Q. Deflector adjustment handle
4. ASSEMBLY
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.

4.1 ASSEMBLY COMPONENTS

The packaging holds the components needed for
assembly (fig. 3 ) listed in the following table:
Component
Snow thrower
Handle
Exhaust chute
Handle assembly screws
Chute assembly screws
Instructions
4.1.1 Unpacking
1. Cautiously open the packaging, paying
attention not to lose components.
2. Consult the documentation in the box,
including these instructions.
3. Remove all the unassembled parts from the
box.
4. Remove the snow thrower from the box.
5. Dispose of the box and packaging in
compliance with local regulations.

4.2 HANDLE ASSEMBLY

1. Connect the auger command cable to the
handle (fig. 5.A)
2. Insert the handle tubes (fig. 3.C) on the lower
one
3. Fasten the parts of the handle using the
specific screws (fig. 3.A) and the knobs
(fig. 3.B), paying attention to position the
specific spacer (fig. 3.D)
4. Adequately tighten the knobs (fig. 3.B)

4.3 DISCHARGE CHUTE ASSEMBLY

1. The 3 screws (fig. 3.E) and the knobs (fig. 3.F)
are pre-assembled on the fastening ring on
the chute (fig. 3.G).
2. Position the discharge chute (fig. 3.J) on the
snow thrower.
3. Insert the three screws (fig. 3.E) and the nuts
(fig. 3.F) as shown in figure 3.
4. Tighten the screws with the knobs.
5. CONTROLS

5.1 IGNITION KEY

Used to start and stop the engine. The ignition key
has two positions (fig. 10.B):
1. Key removed - OFF - the engine stops and
cannot be restarted.
2. Key inserted - ON - the engine can start and
run.
IMPORTANT The engine cannot be started
unless the safety key is fully inserted.
Pos. Q.ty
G 3

5.2 CHOKE CONTROL

C 3
Used to turn on the engine when cold. The choke
J 3
control has two positions (fig. 10.G):
A, B 3
F, E 3
/ /
EN - 5