Advancing The Line Manually - Toro Flex-Force Power System 60V MAX Manual De Instrucciones

1. Speed range switch
2. Lockout trigger
Shutting Off the Trimmer
To shut off the trimmer, release both triggers.
Whenever you are not using the trimmer or are
transporting the trimmer to or from the work area,
remove the battery pack.
Removing the Battery Pack
from the Trimmer
Press the battery latch to release the battery pack and
slide the battery pack out of the machine
1. Battery latch
Figure 8
3. Variable-speed trigger
(Figure
Figure 9
Advancing the Line Using
the Bump Feed
1. Run the tool at full throttle.
2. Tap the bump button on the ground to advance
the line. The line advances each time the bump
button is tapped. Do not hold the bump button
g268420
on the ground.
Note:
The line trimming cut-off blade on the
grass deflector cuts the line to the correct length.
Note:
If the line is worn too short, you may not
be able to advance the line by tapping it on the
ground. If so, release both triggers and refer to
Advancing the Line Manually (page
9).
1. Bump button
Advancing the Line
Manually
Remove the battery pack from the trimmer, then push
the bump button at the base of the spool retainer
while pulling on the trimmer line to manually advance
g268419
the line.
12
12).
Figure 10
g293135