Advancing The Line Manually - Toro PowerPlex 51132 Manual Del Usuario

7. Refer to the following table to interpret the LED
indicators on the battery charger.
Left Light Right Light
Off Red
Red Red
Green Red
Orange Red
Red Blinking Red
Advancing the Line Using
the Bump Feed
1. Run the tool at full throttle.
2. Tap the bump button on the ground to advance
the line. The line advances each time the bump
button is tapped. Do not hold the bump button
on the ground.
Note:
The line trimming cut-off blade on the
grass deflector cuts the line to the correct length.
Note:
If the line is worn too short, you may not
be able to advance the line by tapping it on the
ground. If so, release the trigger and refer to
Advancing the Line Manually (page
1. Bump button
Advancing the Line
Manually
Remove the battery pack from the trimmer, then push
the bump button at the base of the spool retainer
while pulling on the trimmer line to manually advance
the line.
Indicates:
Charger is on; no battery
pack inserted
Battery pack is charging
Battery pack is charged
Battery pack is too warm
Replace the battery pack
12).
Figure 11
Adjusting the Auxiliary
Handle
1. Release the auxiliary-handle latch (A of
12).
2. Slide the auxiliary handle up or down to your
desired height (B of
Important:
bumper.
3. Close the auxiliary-handle latch to secure the
auxiliary handle in place (C of
Trimming
g194633
12
Figure 12).
Do not remove the rubber
Figure
Figure 12
Figure 13
Figure
12).
g189875
g207329