Charging The Battery Pack; Advancing The Line; Advancing The Line Manually - Toro 51484 Manual Del Operador

Charging the Battery Pack

Important: For best results, your battery tool should be
charged in a location where the temperature is more than 0°
C (32° F) but less than 40° C (104° F). To reduce the risk of
serious personal injury, do not store outside or in vehicles.
Charging time will increase if not charged within this range.
1. Turn the battery upside down and line up the battery terminal
with the slot in the charger (Figure 8 and Figure 9).
1. LED indicators
3
1. LED indicators (level of
charge)
2. Release button
2. Slide the battery into the charger until it clicks into place.
3. To remove the battery, press down on the release button
and slide the battery backwards out of the charger.
Figure 8
2. Insert battery here
2
G016223
Figure 9
3. Battery terminal
4. Refer to the table below to interpret the LED indicators on
the battery charger.
LED COLOR
Top Bottom
Red Red
Red Green
Red Orange
Red Green
Red (blinking) Red (blinking)

Advancing the Line

Note: The trimmer is equipped with an auto-feed head.
1. With the trimmer running, release the switch trigger.
2. Wait two seconds, then slide the lock switch back to the On
position and squeeze the trigger.
Note: The line will extend approximately 1/4 inch (6 mm)
with each stop and start of the switch trimmer until the line
reaches the length of the grass deflector blade.
3. Resume trimming.

Advancing the Line Manually

Remove the battery from the trimmerk, then push the red button
at the base of the spool retainer while pulling on the trimmer line
to manually advance the line.
1
8
Indicates:
Battery is charging
Fully charged
Battery is too
warm: Remove
for approximately
30 minutes
No battery present
Defective battery