Floor Cleaning - Kärcher FR Classic Manual De Instrucciones

Install/remove/replace the high
pressure nozzles
 Loosen the safety clamp with a screw-
driver.
 Remove the protective grid.
 Install / replace the high pressure nozzles.
 Mount the protective grid on the pin.
 Push the safety clamp in until it locks.

Floor cleaning

Mount the spray lance
 Connect the spray pipe of the high pres-
sure cleaner to the FR Classic and
tighten it with a wrench (width 24).
6
Install the spray pipe on high
pressure cleaner K6. or K7.
1 Hand spray gun with bayonet connection
2 Steel pipe extension 0.5 m (order no.
4.760-558.0 or steel pipe extension 0.9
to 1.7 m (order no. 2.639-722.0)
3 Adapter (order no. 4.762-402.0)
4 FR Classic
 Connect the components with one an-
other as shown above.
 Guide the surface cleaner so that it re-
mains close to the surface to be
cleaned.
Caution
Do not run over protruding corners!
The surface cleaner is not suitable for srap-
ing or scrubbing!
Outdoor surfaces should be swept before
the surface cleaner is used to avoid damag-
ing the high-pressure nozzles.
– 2
EN
Application