Important; Electrical Safety - Jacuzzi SKYLINE 190 Instalación

n L'impianto elettrico dell'immobile deve essere provvi-
sto di interruttore differenziale da 0,03 A.
n
Le parti contenenti dei componenti elettrici, ad ecce-
zione dei dispositivi di comando remoto, devono esse-
re posizionati o fissati in modo che non possano cadere
dentro la vasca. Componenti e apparecchiature sotto
tensione non devono essere accessibili a chi è immerso
nella vasca.
n Le vasche idromassaggio Jacuzzi® sono provviste di
morsetto, posto nelle vicinanze della pompa e contrad-
distinto dal simbolo , per il collegamento equipoten-
ziale delle masse metalliche circostanti, come previsto
dalle norme EN 60335.2.60.
m
ATTENZIONE! Scollegare l'apparecchiatura dalla linea
di alimentazione elettrica prima di effettuare qualsiasi
intervento di manutenzione.

IMPORTANT



Please ensure that you thoroughly check the product
upon receipt since we cannot accept responsibility for any
damage reported after installation. Should you find any
damage, please immediately notify the forwarder.

Check that the arrangements comply with the instruc-
tions included in the pre-installation instructions.

Check for any damage or defects by removing the protec-
tive plastic film (damages from impact or scratches reported
after installation are not covered by our guarantee).

Check that the clamps holding the rubber couplings and
the air lines are tightly fastened.

The installation of the whirlpool baths can be made
against finished (tiled) walls and floor.
The panels allow access to electromechanical devices
installed under the bath rim, as well as proper aeration re-
quired for water-air mixture during hydromassage.
Aeration must be guaranteed also if Jacuzzi® panels are
not used (see "Instruction for pre-installation").
Panels must be firmly installed and proper tools must be
used when being removed.
Openings, holes, grids, used for aeration, should not al-
low the introduction of objects having a diameter of 12 mm
or larger.
m
CAUTION: (IEC 60335-1) The pressure of the water sys-
tem supplying water to the appliance must not exceed
600 kPa (6 bar).

Electrical safety

Jacuzzi®" hydromassage products are safe appliances, manufac-
tured according to EN 60335.2.60, EN 55014 and EN 55014-2.
They are tested during production to guarantee user safety.
5