Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Brewing 1 – 4 Cups
(Models ESX30, ESX33 Only)
If you want to brew 4 cups or less, the 1 – 4 Cup mode will slow the
brewing cycle to ensure optimal saturation of the ground coffee beans.
Note: Use only the proper amount of ground coffee and fill the water reservoir
with 4 cups or less of water.
1. Press the SELECT button twice.
2. The ON and 1 – 4 Cup Indicator Lights should be illuminated.
If you want to brew 4 cups or less at a preset time, follow Steps 1 – 3
in the "Presetting Your Brewer" section.
1. Press the SELECT button twice.
2. The ON and 1 – 4 Cup Indicator Lights should be illuminated.
Adjusting the Warmer Plate Temperature
(Models ESX30, ESX33 Only)
After the coffee is brewed, you can keep the coffee at your preferred temperature.
Turn the Warmer Temp knob clockwise to increase the temperature, or turn
counterclockwise to decrease the temperature. To maintain a constant
temperature, you may need to lower the warmer plate temperature as
you decrease the amount of coffee in the pot. DO NOT allow the decanter
to boil dry. This will damage the decanter.
Audible Indicators
(Models ESX30, ESX33 Only)
When the Coffeemaker is finished brewing and your coffee is ready,
your Coffeemaker will beep five times.
Just before the Coffeemaker shuts off automatically, it will beep three times.
Upon completion of the clean cycle, the Coffeemaker will beep once.
Cleaning
Your Coffeemaker must be cleaned when you begin to notice excessive steaming,
the cleaning cycle indicator light is blinking during normal brewing cycles, or the
brewing time increases considerably. This condition is caused by a build-up of
lime and mineral deposits from your water. If the pumping action stops before all
the water has been pumped out of the machine, the appliance requires cleaning.
The frequency of cleaning depends on the hardness of water used.
The following table gives a suggested cleaning schedule.
ES Series M
14
Publicidad
Capítulos
Tabla de contenido
