Haier QFW150 Serie Manual Del Propietário página 23

TROUBLESHOOTING TIPS
Problem
Water does not Automatic self system checks
enter washer or
enters slowly
Water valve screens are
stopped up
Inlet hose screen washers are
stopped up
Pump filter may be clogged
Fill hoses may be kinked
Water supply is turned off
Energy efficiency
Insufficient water supply
The washer door is open
Incorrect fill hose connection
Wrinkling Improper sorting
Overloading
Incorrect wash cycle
Repeated washing in water that
is too hot
Grayed or Not enough detergent
yellowed clothes
Not using HE (high efficiency)
detergent
Hard water
Water is not hot enough
Detergent is not dissolving
Dye transfer
49-3000191 Rev. 1
Possible Cause
After Start is pressed, the washer does several system checks. Water
will flow several seconds after Start is pressed.
Turn off the water source and remove the water connection hoses
from the upper back of the washer. Use a brush or toothpick to clean
the screens in the machine. Reconnect the hoses and turn the water
back on.
Turn off the water source and remove the inlet hoses from the wall
faucets. Use a brush or toothpick to clean the screen washers in the
end of the hoses. Reconnect the hoses and turn the water back on.
See the Care and Cleaning section on how to clean the Pump Filter.
Check that fill hoses are not kinked or clogged.
Turn on both hot and cold faucets fully.
This is an energy-efficient washer. As a result, the temperature
settings for this washer may be different than for a non-energy-
efficient washer.
Make sure that the water supply is turned on. Make sure that the
water faucets are turned to their completely open position.
The washer door must be closed for all washer cycle operations. If
the door is opened during the washer operation, all functions will
stop, including water filling.
Make sure that the fill hoses connect the hot water supply to the hot
inlet on the washer and the cold water supply to the cold inlet on the
washer (hot to hot, cold to cold).
Avoid mixing heavy items (like work clothes) with light items (like
blouses).
Load your washer so clothes have enough room to move freely.
Match cycle selection to the type of fabric you arewashing (especially
for easy care loads).
Wash in warm or cold water.
Use correct amount of detergent.
Use only HE detergent.
Use hottest water safe for fabric.
Use a water conditioner like Calgon brand or install a water softener.
Make sure water heater is delivering water at 120°–140°F (48°–60°C).
Try a liquid HE detergent.
Sort clothes by color. If fabric label states wash separately, unstable
dyes may be indicated.
What To Do
23