Dispensing Stop Function; Repetition Function; Special Functions - LaCimbali M1 Uso E Instalacion

Use key to stop dispensing before the programmed
dose has been reached.
NOTE: use of the
programmed parameters.
stop dispensing" function has been enabled by the installer,
dispensing can be stopped by pressing the selection key
again.
This function can be activated in various ways:
1) Press any one of the selection keys and after about 3
seconds press the same key again for the number of
dispensed drinks required.
The number of dispensed drinks programmed is
indicated on the top left of the display. Press the
button and keep pressed for about 3 sec. to reset.
2) Setting the desired number at the repeats entry in the
beverage recipe (see CLIENT PROGRAMMING and
paragraphs referring to Key Menu).
The special function key (25) described here below can
only be activated by an installation technician.
The key can be personalized with one of the following
functions:
- II Selection (according to the function, dispensing of a
second drink associated to a dispensing key);
- Stop (stops products from being dispensed);
- Deactivated (deactivates key);
- Hot water stop (stop water from being dispensed).
SECOND SELECTION Function
Enables the dispensing of a second type of drink associated
to the dispensing keys.
This function can be obtained only if a special key (25) is
set for the group chosen for dispensing, with the second
selection function.
At this point, if the special key is pressed and followed
by one of the dispensing keys that corresponds to the
beverage and the desired dose, the second beverage that

Dispensing STOP function

button will not modify the

REPETITION Function

12.1 Special functions

NOTE: These functions are deactivated when error
messages and/or codes are displayed and the
item "Program. block" is set on "YES".
M1
25
was set on the selected dispensing key will be dispensed.
Note. To cancel the second selection operation press
the key again (25).
13 EN
M1 Program
25