Installing Kickstands - Leer PACE EDWARDS ULTRAGROOVE ELECTRIC Instrucciones De Instalación

• Another way to check proper fit is to test the side to side play of the handle assembly at the canister and
at the tailgate end of the rails. There should be, at the minimum, enough play to allow the cover to move
freely with no drag and at a maximum 1/8 inch per side. More than 1/8 inch per side may result in the cover
opening unintentionally and in severe cases it may fall between the rail tracks and damage the cover
There are "Stick on Shims" on the shim brackets that can be removed if the unit is too tight and "Stick on
Shims" in the hardware pack that can be added if too loose. Refer to Figure 6C for "Stick on Shims"
if adjustment is needed.
• Run the adjusting bolt inward toward the bed wall, putting some pressure on the foot, then continue
running the bolt inward using the knob until the rail is visually level. If the rail is difficult to level, loosen
the clamp, continue running the adjusting bolt in a couple turns, re-tighten the clamp, then verify the rail
is level and that the bracket/shim is contacting the bed rail.
Adjusting
Kickstand Base
Bolt
Longer Orientation
STEP 8: INSTALLING KICKSTANDS
FIG. 8A
FIG. 10A
Pivot
Flat
Foot
Washer Lock
Washer
Flipping
Base
FIG. 8C
FIG. 10B
• At the tailgate ends of the rails, place the
Straight Grip opposite of the relief used by
the clamp extension. This will position the
Kickstand on the flat section of bed wall.
If the assembly is not positioned squarely
against the bed wall, the assembly will
rotate out of position, or the foot or knob
can dislodge when the rail is flexed or
loaded (FIG. 8C).
Adjusting
Bolt
Turn- To-Adjust
Knob
Pivot Foot
Wing Nut
Shorter Orientation
Flat
Washer
Lock
Washer
FIG. 8B
Win
Nu
11