Tools Required For Assembly; Before You Start; Canister Drain Hole Locations; Remove From Packaging - Leer PACE EDWARDS ULTRAGROOVE ELECTRIC Instrucciones De Instalación

Side Cut
Utility
or Needle
Knife
Nose Pliers
Read instructions carefully and watch the installation
video before you start. You may use QR Code or go to
https://www.pace-edwards.com/ford-ultragroove
for the installation video and other helpful material.
CANISTER DRAIN HOLE
LOCATIONS:
This tonneau cover is designed to carry rainwater
from the cover into the canister and then out
through the drains. You will need to remove
the standard OE plastic/rubber access
ports that cover the drain tube holes and
replace with the given Drain Plugs that
are provided in your kit. This will need
to be done before installing the cover.
STEP 1: REMOVE FROM PACKAGING AND REVIEW CONTENTS
A complete unit will consist of one canister box (marked box 1 of 2) and one rail box (marked box 2 of 2).
Remove the Top Cover, Canister, Clamp pack, Hardware pack, Foam, Clamp Extensions and Drain Tubes from
the Canister box. Remove the rails from the rail box (see caution below). Perform a quick inventory of the
packaging contents to ensure all parts are there. Using the 3/8" wrench or socket, remove the 2 bolts holding
the plywood packaging supports on the ends of the canister. Discard plywood packaging supports and bolts.
TO AVOID SCRATCHING THE SURFACE OF THE RAILS, DO NOT SLIDE THEM OUT
OF THE END OF THE BOX. OPEN THE BOX ALONG THE LENGTH, USE PLIERS TO PULL THE
TOOLS REQUIRED
FOR ASSEMBLY
3/8" 5/32"
Wrench Allen
Wrench

BEFORE YOU START!

Drain Plugs
Driver Passenger Side
Side
STAPLES, LIFT THE RAIL OUT. DO NOT USE A KNIFE TO CUT THE BOX.
Tape Measure #2 Phillips
Screwdriver
Note: Driver side/Passenger
side specific. Drain Holes located
to the outside of the bed.
7/16" Socket
Masking Tape
Torque
Wrench
Drain Tube Holes
3