Descargar Imprimir esta página

Amtra MODERN TANK Manual Del Usuario página 6

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
MODERN TANK
NOTE: BEFORE STARTING ANY OPERATION OF USE AND MAINTENANCE OF THE DEVICE, PLEASE READ THE MANUALS OF USE AND MAINTENANCE.
THE MANUFACTURER CANNOT BE HELD IN ANY CASE RESPONSIBLE OF ACCIDENTS OR DAMAGE RESULTING FROM INAPPROPRIATE USE OF THE DEVICE, AS
WELL AS EVEN PARTIAL FAILURE TO OBSERVE THE SAFETY REGULATIONS AND THE INTERVENTION PROCEDURES DESCRIBED IN THE MANUALS.
ATTENTION: THE DEVICE EQUIPMENT CAN BE PUT INTO OPERATION ONLY AFTER IT HAS BEEN CORRECTLY INSTALLED AND CONNECTED AND THAT THE USER
HAS PREVIOUSLY READ THE MANUAL.
CAUTION: This symbol on the product label and on its packaging indicates that this instruction manual must be read carefully before the
appliance is started up or serviced. be held responsible for any damage caused by this appliance if you have not read and understood this instruction
manual carefully or if you have not followed this.
In order to avoid any type of accident, carefully observe the following warnings (in addition to the most basic safety regulations)."
-This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- WARNING: Unplug or switch off all appliances in the aquarium or pond before carrying out maintenance.
If the connection plug of some appliance or the socket are wet, turn off the main switch before disconnecting the power cord of the appliances present.
- The supply cord cannot be replaced. If the cord is damaged the appliance should be scrapped.
„- Check the voltage on the device label and ensure it corresponds to the main power supply.
- When the device is plugged to the mains, ensure that the lowest part of the lead is lower than the socket, to avoid any drops of water that are on the
lead flowing into the socket. If the cable is wet, do not touch the plug with your hands and before disconnecting the device, turn the mains switch off.
- We recommend that this device and other electrical aquarium devices should be connected to power supplies with ground fault circuit interrrupters
lnd 30 mA."
During installing the appliance or maintaining it, please don't lift it using the power cord.
Before putting the appliance into operation, make sure you have installed it correctly.
Never carry out repairs or technical modifications to the appliance and use only original spare parts.
„Preliminary checks
Checking for damage - Verify that the various parts of the device does not display physical damages due to bumps, tears or abrasions.
Check in particular:
• That there are no signs or dents, indicative of bumps caused by transport.
• The integrity of the the electrical cables."
„Damage Reporting Procedure
If any damage is discovered, stop the connection procedure and report the nature of the damage to the Customer care office of the manufacturer."
KEEP THESE INSTRUCTIONS CAREFULLY!
HOW TO PLACE THE AQUARIUM: The aquarium has to be placed away from direct sunlight sources and other heat sources (heaters, etc...) to avoid the
overheating and the formation of algae. Do not place where eventual water could splash causing damages.
„GB- Precautions to follow to avoid the electrocution. This is an aquarium that it contains water; do not try to repair it yourself.
1- If electrical parts fall in water, do not try to keep them out. Unplug immediately the electrical device from the socket and then pull the electrical part
out the water.
2- After have accurately installed all the parts of the aquarium, be sure that the electrical parts are not humid before connecting the thorn to the socket.
3- Do not start the aquarium if you have found working problems. Contact immediately your retailer or a technician.
4- If the cable is damaged do not start the aquarium. Do not try to replace it yourself, call a technician or ask for help to your retailer.
5- Avoid that the electrical socket will dirt or wet. An effective method is to make a drip loop: let the cable hang under the electrical socket, in that way
water drops cannot be guided towards the thorn.
gb
ISTR_MODERN_TANK.indd 6
09/01/19 08:45

Publicidad

loading