Emtec H340 Guia Del Usuario página 20

- quickly press and release the S key followed by pressing and releasing the DVD Mode key
to send the VCR key command.
This method can be applied similarly to all Combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR, etc) and is
available for all Modes. This feature is not supported by all codes.
6. System Setup Options
Pressing OK at SYSTEM SETUP accesses the System Setup Options for Volume Punch-Through control
Setup, Time Setup, Date Setup, Backlight Setup and System Reset.
6.1 Vol/Mute Control Setup
Volume/Mute Control and Punch-Through Feature:- This remote allows you to select which Mode controls
your Volume/Mute keys. The remote is initially set (factory default) for all Modes programmed with "Visual"
codes (e.g. TV, VCR, DVD, PVR, SAT & CABLE) and "Audio" codes (e.g. CD & AUDIO) to use their own
Volume/Mute control if present. If the programmed "Visual" code has no Volume/Mute operation of its own
then those keys will punch-through control to the TV Mode device without needing to change to TV Mode.
Setting Volume/Mute Control and Punch-Through - Any Mode chosen for Volume/Mute control MUST have
its own Volume/Mute function either in the programmed code or learned otherwise the Volume/Mute keys
will do nothing.
6.1.1 Set All Vol. to one Mode
Setting ALL Volume/Mute Control to any one Mode e.g. TV :- This routine will set all Modes to punch-
through to any one chosen Mode for Volume/Mute key control without the needing to change to that Mode.
a. Press and hold S key until "Code Setup" is displayed (takes approximately 2-3 seconds).
b. Release S key.
c. Using the Up/Down keys, navigate to "System Setup". Press and release OK key. "Vol/Mute
Control Setup" is displayed.
d. Press and release OK key. "Set All Vol. to 1 Mode" is displayed.
e. Press and release the OK key. "Set All Vol. to Mode?" is displayed.
f. Press and release desired Mode key (TV, VCR, DVD, etc.) for Volume/Mute control.
g. "Please Wait" will be displayed briefly followed by "Success" and the remote will exit Setup and
return to normal operation.
h. All Modes will now punch-through to your chosen Mode for Volume/Mute control.
If the chosen Mode has no Volume/Mute commands of its own, "Volume Control Error" will
be shown in the display and the remote will exit Setup routine and return to normal
operation.
6.1.2 Set Vol. for one Mode
This routine will set any Mode to use only its own Volume/Mute control i.e. Volume/Mute punch-through is
disabled for this Mode. Note: before using this routine, check that the chosen Mode has its own
Volume/Mute functions, either in the code or by learning, otherwise the Volume/Mute keys will do nothing.
a. Press and hold S key until "Code Setup" is displayed (takes approximately 3 seconds).
- 17 -