SPORT-ELEC FREE ACTION Manual Del Usuario página 36

The Free Action is intended for use in the electromagnetic environment specified below. The customer or the user of
EMISSIONS
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/ flicker
emissions
IEC 61000-3-3
The Free Action is intended for use in the electromagnetic environment specified below. The customer or the user of
IMMUNITY
TEST
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage
dips, short
interruptions
and voltage
variations
on power supply
input lines
IEC 61000-4-11
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
- 64 -
GUIDANCE AND MANUFACTURER'S DECLARATION
ELECTROMAGNETIC EMISSIONS
the Free Action should assure that it is used in such an environment.
COMPLIANCE
Group 1
Class B
Conform
Class A
Conform
GUIDANCE AND MANUFACTURER'S DECLARATION
ELECTROMAGNETIC IMMUNITY
the Free Action should assure that it is used in such an environment.
IEC 60601 TEST LEVEL
±6 kV contact
±8 kV air
±2 kV for power supply lines
and dc lines
±1 kV for input/output lines
±1 kV line(s) and neutral
± 2 kV line(s) to earth
<5 % U (>95 % dip in U )
T T
for 0,5 cycle
40 % U (60 % dip in U )
T T
for 5 cycles
70 % U (30 % dip in U )
T T
for 25 cycles
<5 % U (>95 % dip in U )
T T
for 5s
3 A/m
NOTE - U is the a.c. mains voltage prior to application of the test level
T
ELECTROMAGNETIC ENVIRONMENT - GUIDANCE
The Free Action uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
The Free Action is suitable for use in all establishments, including domestic
establishments and those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic purposes.
COMPLIANCE LEVEL
±6 kV contact
±8 kV air
±2 kV for power supply
lines
Not applicable for input/
output lines
±1 kV line(s) and neutral
N/A(§7.2 EN61000-4-5)
<5 % U (>95 % dip in U )
T T
for 0,5 cycle
40 % U (60 % dip in U )
T T
commercial or hospital environment. If a dips or an
for 5 cycles
70 % U (30 % dip in U )
T T
for 25 cycles
<5 % U (>95 % dip in U )
T T
for 5s
3A/m
ELECTROMAGNETIC
ENVIRONMENT - GUIDANCE
Floors should be wood, concrete or ceramic tile.
If floors are covered with synthetic material, the
relative humidity should be at least 30 %.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
interruption of mains power occurs, the current of
the Free Action may be dropped off from normal
level, it may be necessary to use uninterruptible
power supply or a battery.
Power frequency magnetic fields should be at
levels characteristic of a typical location in a typical
commercial or hospital environment.