Publicidad
Idiomas disponibles
Idiomas disponibles
Backlock Rod Replacement
1.
Pu
ll off old backlock rod, rotate 3-IN-1 control around and
unfasten pneumatic activation cable. 3-IN-1 control should
now rotate freely a full 360 degrees.
2.
From backside of 3-IN-1 control, drill out the backlock rod hole
using a 7/32" drill bit. The hole can be easily accessed with
a drill when the 3-IN-1 control is rotated with the hole in the
bottom-most position.
7/32" DRILL BIT
2
3-IN-1 CONTROL
1
BACKLOCK AXLE
BACKLOCK ROD
PNEUMATIC CABLE
3-IN-1 CONTROL
Page 7 of 30
939504598 Rev H
Publicidad
