Publicidad
Idiomas disponibles
Idiomas disponibles
Backlock Rod Replacement CONTINUED...
3.
Snap the rod end clip into the hole completely.
4.
Reconnect pneumatic cable in 3-IN-1 control.
5.
Place the NEW backlock rod into the backlock axle, then
into the rod end clip/3-IN-1 control assembly. Rotate rod
end clip until it snaps over the rod.
6.
Discard old backlock rod.
7.
Place cable tie around backside of backlock rod and
rod end clip assembly.
8.
Fasten cable tie tightly to the backlock rod and rod end
assembly and cut off excess cable tie with scissors.
7
CABLE TIE
ROD END CLIP
3
BACKLOCK ROD
5
ROD END CLIP
MAGNIFIED VIEW
BACKLOCK
ROD
MAGNIFIED VIEW
Page 8 of 30
939504598 Rev H
Publicidad
