Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not remove or deface warning labels. Removing
labels increases the risk of exposure to radiation.
•
Position the laser securely on a level surface. Damage
to the laser or serious injury could result if the laser falls
Laser Information
•
The DCE088R and DCE088G Laser Levels are Class 2
laser products.
•
The DCE088R and DCE088G lasers are self-leveling
laser tools that can be used inside and outside for
horizontal (level), vertical and plumb alignment projects.
WARNING:
Read and understand all instructions. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious personal injury.
Work Area
•
Keep your work area clean and well lit. Cluttered benches
and dark areas invite accidents.
•
Do not operate laser tools in explosive atmospheres, such
as in the presence of flammable liquids, gases, or dust.
• Keep bystanders, children, and visitors away while operating
a laser tool. Distractions can cause you to lose control
Electrical Safety
• Use battery operated tool only with the specifically
designed batteries. Use of any other batteries may create
a risk of fire.
Product Overview
WARNING:
Never modify the tool or any part of it. Damage to the
laser or personal injury could result.
Figure 3 -
Battery Interface
Figure 2 -
Pendulum Lock
Figure 2 -
C
Keypad
Figure 5B -
ON/OFF button: horizontal laser line
Figure 5B -
ON/OFF button: vertical laser line
Figure 5B -
Battery Meter
Figure 3 -
Magnetic pivot bracket
Figure 3 -
H
Keyhole slot
Figure 5A -
Tripod thread fitting (1/4 - 20" & 5/8-11)
A
B
D
E
F
G
I
Figure 5A -
Ceiling Mount
Figure 5A -
K
Clamp
Figure 5A -
Screw Hole
Batteries and Power
•
This tool is powered by the following DeWALT 10.8V Battery
packs: DCB120, DCB127 or may also be powered using the
DEWALT AA Starter pack which can carry 4 x AA batteries.
Note: The AA starter pack is recommended only for use with
the red laser
Battery Installation / Removal
(See figure
)
3
Using the AA Starter Pack:
CAUTION:
The AA starter pack is designed specifically for
use only with the DeWALT 10.8V compatible laser
products and cannot be used with any other tools Do
not attempt to modify the product.
To install batteries:
•
Lift up the battery compartment cover as shown in Figure
4
.
•
Insert four fresh AA batteries in the compartment, placing
the batteries according to (+) and (–) on the inside of the
compartment.
•
Install the AA starter Battery pack as shown in Figure
Using the 10.8V DEWALT Rechargeable
Pack:
•
Install the 10.8V Battery pack as shown in
Figure
3
.
WARNING:
Batteries can explode, or leak, and can cause
injury or fire. To reduce this risk carefully follow all
•
Carefully follow all instructions and warnings on the battery
instructions on the label and package and accompanying
Battery Safety Leaflet.
•
Always insert batteries correctly with regard to polarity
(+ and –), marked on the battery and the equipment.
•
Do not short battery terminals.
•
Do not charge disposable batteries.
•
Do not mix old and new batteries. Replace all of them at the
same time with new batteries of the same brand and type.
J
M
3
.
5
Publicidad
