Simu T3.5 Manual Del Usuario página 7

If you do not want to use this transmitter as the individual control:
- cut the power supply (2 seconds minimum).
- repeat the opération 4.1* with a new transmitter and then go to step §5.
* In this case, the motor will run for half a second in both directions, that means the limits setting is already done
Programming the first individual point of control
5
This operation can only be performed from the transmitter that was used for operation 4.1.
- Press the transmitter "PROG" Key for approxi-
mately one second. The motor will run for a half
a second in one direction and then in the
other.Your transmitter is now programmed
to control the motor in stable mode.
Programming a new (individual, group or main) control point:
6
6.1 : Open the memory of the receiver from
the control transmitter:
- Press the "PROG" key of the transmitter for
about three seconds. The motor will run for a
half a second in one direction, then in the other.
6.2 : Validate the operation from the new
transmitter you want to programm:
- Press the "PROG" key of the transmitter for
about one second. The motor will run for a half
a second in one direction, then in the other.
- For group controls, repeat operations 6.1 and 6.2 for each motor in the group.
- For main controls, repeat operations 6.1 and 6.2 for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations 6.1 with a programmed transmitter,
then perform the operation 6.2 with the transmitter to be deleted.
Recording and controling intermediate position
7
Recording :
- Position the motor on the
wanted position.
- Press 5 seconds on the
"stop" key. The motor
will run for 1/2 second in
one direction and then in
the other.
c - After the adjustment of the DOWN (a) and the UP (b) end limits, confirm the
settings:
- Press 2s on the "stop" key to validate the settings. The motor will stop and will run for
half a second in one direction and then in the other. Go to next step.
2s
5s
PROG 1s
PROG 3s
PROG 1s
Controling :
- Press on the "stop" key
for 0,5s. the motor goes
to the intermediate posi-
tion.
>>
>>
>>
0,5s
3 / 4