SICK IN3000 Direct Instrucciones De Operación página 173

Operating instructions
IN3000 Direct

WARNING
8014173/XT35/2013-10-28 © SICK AG • Industrial Safety Systems • Germany • Subject to change without notice
Electrical installation
Prevent the occurrence of a potential difference
between the load and the protective device!
 If you connect loads to the OUT1/OUT2 outputs,
then you must connect the 0 V connections for
these loads and the related protective device
separately, one after the other, to the same 0 V
terminal strip. Only then is it ensured that in the
case of a fault, it is not possible for a potential
difference to occur between the 0 V connections for
the loads and the related protective device.
Chapter 5
173