DeWalt DCF620 Traducido De Las Instrucciones Originales página 38

ENGLISH
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
2
is 1 mm ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fi g. 2)
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
NOTE: Make sure your battery pack (f) is fully
charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the notch inside the tool's handle with the
battery pack (fig. 2).
36
2. Slide the battery pack firmly into the handle until
you hear the lock snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (e) and firmly pull the
battery pack out of the tool handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
FUEL GAUGE BATTERY PACKS (FIG. 2)
Some D
E
which consists of three green LED lights that
indicate the level of charge remaining in the battery
pack.
To actuate the fuel gauge, press and hold the fuel
gauge button (t). A combination of the three green
LED lights will illuminate designating the level of
charge left. When the level of charge in the battery
is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the
charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based
on product components, temperature and end-user
application.
Changing Bit Holders (fi g. 3)
1. Rotate the locking collar (c) 1/4 turn to unlock
nose cone from gear case.
2. Pull nose cone (d) off of gear case.
3. To remove:
a. Grab the bit holder (v).
b. Push it into the gear case depressing the
sleeve (u).
c. Rotate the bit holder until the clutch
engages.
WALT battery
E
d. While holding the sleeve depressed, pull the
bit holder out.
4. Push and rotate the new bit holder into
gearcase, depressing the sleeve, until ball lock
snaps in groove in bit holder shank.
5. Replace nose cone (d) by placing on gear case
and rotating collar 1/4 turn to align arrow on
gear case with the lock symbol on collar.
Changing Bit Tip (fi g. 3)
1. Rotate the locking collar (c) ¼ turn to unlock
nose cone from gear case.
2. Pull forward on nose cone (d) and remove it
from clutch housing.
3. Use pliers to remove worn bit and install new bit
tip.
WALT battery packs include a fuel gauge