Telephone Installation; Desk Or Tabletop Installation; Tone/Pulse; Wall Mount Installation - Panacom PA-7300M Manual Del Usuario

4. Snap the battery compartment lid back into place and replace the
base plate.

TELEPHONE INSTALLATION

Your two-line phone can be placed on a level surface such as a
tabletop or desk, or you can mount it on the wall.

DESK OR TABLETOP INSTALLATION

Plug the telephone line cord into a modular jack (RJ11 or RJ14) and
into the PHONE LINE jack on the back of the unit.
Plug the handset cord into the handset, and into the telephone jack
on the left side of the unit.

TONE/PULSE

Set the PULSE/TONE switch to TONE if you
have Touch-Tone service, or to PULSE if you
have Pulse (rotary) service.

WALL MOUNT INSTALLATION

1. Rotate the handset hook.
2. Set the TONE/PULSE switch to TONE if you
have touch-tone service or to PULSE if you have
pulse (rotary) service.
3. Remove the base plate from the back by
pressing down on the snap tabs located at the
top and then lifting it off.
4. Plug the phone line cord into the phone jack
on the back of the unit.
5. Reverse the direction of the Base Plate and
replace it by putting the tabs into the slots on
the top of the unit first, and then snapping the
bottom tabs into place.
6. Connect the phone cord to the modular
jack on the wall.
7. Slip the mounting holes over the wall plate
posts and slide the unit down firmly into place.
(Wall plate not included.)
8. Plug the handset cord into the handset and
Pg. 7