Operation In The "Output" Mode; In All Operations Modes; Process Chart And Function Illustration; Cleaning And Care - Hydas 4509.1.00 Instrucciones Servicio

TENS (Transcutaneous electrical nerve stimulation), and EMS (Electrical muscle stimulation).
• Under this mode press [TENS] button to choose TENS mode.
• Under this mode presses [+] button enter into treatment mode.
• Under TENS function press [EMS] button enter into EMS function. LCD shows EMS program 1.
• Under EMS function press [EMS] button to adjust program No.
• Under EMS function press [TENS] button enter into TENS function, LCD shows TENS program 1.
• Under TENS function press [TENS] button to adjust program No.
• 5 TENS programs as well as 5 EMS programs are available.
• Under this mode press [ ] button return to "Power off " mode. • Under this mode press [ ] button return to "Power off " mode.

5.5 | Operation in the "output" mode

• Under this mode press [ ], output wave shape stops and power off . • Under this mode press [ ], output wave shape stops and power off .
• Under this mode press [+], the output intensity of channel A will increase 1 level, and amplitude output
appears 1 increase.
• Under this mode press [-] to decrease intensity, wave amplitude decreased and transferred to 0 to return
to standby mode.
• Under this mode, if electrodes pad are not stacked well, after two pulse cycles will automatically return to
standby mode and corresponding electrode symbol will show up.
• Under this mode, to press [EMS] under TENS function will enter into EMS function, LCD display EMS 1 and
intensity at the lowest intensity 0 output.
• Under this mode, to press [TENS] under EMS function will enter into TENS function, LCD display TENS 1
and intensity at the lowest intensity 0 output.
• Output will stop after the end of each countdown and return to standby mode. The remaining time of
operation is shown in the display.
• Note: When turn on the device; the output mode is the last treatment mode even after the batteries have
been removed.

5.6 | In all operations modes

• Power supply voltage less than Approx. 3.3V the battery symbol will blink and remind the user to change
the battery. In this status the device will turn off after 180 seconds.
Caution:
If the stimulation levels are uncomfortable or become uncomfortable, reduce the sti-
mulation intensity to a comfortable level and contact your medical practitioner if problems persist.

6 | Process chart and function illustration

TENS Program table:
Program Workingtime (min)
TENS 1 30
TENS 2 30
TENS 3 30
TENS 4 30
TENS 5 30
EMS Program table:
Program Workingtime (min)
EMS 1 30
EMS 2 30
EMS 3 20
EMS 4 25
EMS 5 30

7 | Cleaning and Care

7.1 | Tips for skin care

To avoid skin irritation, especially if you have sensitive skin, follow these suggestions:
22
Frequency Pulse width (µS)
80 200
2 250
2 200
2/80 250/200
2~80 200
Frequency Pulse width (µS)
50 250
20 250
30~80 250
30~45 250
30~45 250
Waveform property
normal
normal
normal
han
FM
Waveform property
EMS
EMS
EMS
EMS
EMS