KAS ZENITH Manual Del Usuario página 9

EN
be both comfortable and close fitting. With the chin strap fastened and correctly
adjusted, always check that the helmet does not squeeze the head nor moves
freely back and forth (see Fig. 1).
HELMET ADJUSTMENTS: Wear the helmet and adapt the size by turning the
rear wheel (clockwise to tighten the size and counter-clockwise to enlarge it) or
simply (only for models equipped) by drawing the two quick-closing elements
to obtain the desired tension (Fig. 2). Position the size adjustment system in the
nuchal area as shown (Fig. 3), tilting it and adjusting it in height. For versions
equipped with a chin strap, fasten it by inserting one buckle strap into the other
until it clicks into place (Fig. 4a). Pull the chin strap to check that the buckle is
locked (Fig. 5). Adjust the length of the chin-strap to firmly secure the helmet on
your head. The rubber ring must be positioned on end of the tape to prevent
it dangling. Adjust the lateral retractor of the chin strap by sliding it along the
straps until you find the desired position below the ear (Fig. 6). To remove the
helmet from the head, open the chin-strap by simultaneously pressing the
buttons on each side of the buckle (Fig. 4b).
SPARE PARTS: Changes, replacements and/or removals of one or any of the
original components of the helmet are prohibited unless authorized by the
manufacturer. Only use original KASK spare parts. The helmet should not be
modified to accommodate other accessories other than those described below.
If necessary contact your retailer or the manufacturer directly.
ZENITH MODEL HELMET ACCESSORIES: Chin strap (only for BA versions) -
lamp clip - visor attachment adapters - reflective stickers - sahariana - sombrero
- earmuffs - eye protection visor (EN166) - face shield (EN166) - plastic mesh
protector (EN1731 ) - metal mesh protector (EN1731) - replacement padding -
winter padding.
Check with your retailer or manufacturer the actual availability of the accessories
listed above. Follow the installation and operating instructions supplied with the
accessory. Only use accessories approved by the manufacturer.
CHECK: Before using the helmet check its integrity in all its parts. Following a
violent impact even if the damage is not visible replace the helmet, as it may
have exhausted its ability to absorb further shocks and provide the expected
protection.
CLEANING: Clean the helmet (and any accessories) using only water, mild
soap and a soft, clean cloth, and let it air dry at room temperature. The internal
padding can be removed and washed by hand in cold water or in the washing
machine (max. 30°C). Never use chemical cleaning products or solvents.
STORAGE: When not in use, it is best to keep the helmet at a temperature
between 5°C and 35°C, protected from direct sunlight and away from heat
sources, we recommend to store the helmet in its original package.
APPLICATION OF ADHESIVES: Do not apply adhesives, solvents, stickers and
paint if not in compliance with the manufacturer's specifications. Any repair or
modification not foreseen may adversely affect the protective function of the
helmet.
9