Tabla de contenido
Publicidad
Chapter 2: Installation
Wall-Mounting the Switch
The switch can be mounted horizontally on a wall using the two keyhole
slots in the bottom of the switch.
To mount an AT-FS716L switch onto a wall, perform the following
procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
2. If attached, remove the rubber feet, data cables, and power cord from
the switch.
3. Select a wall location for the switch.
4. Mark two hole locations on the wall.
5. At the marked locations for the holes, pre-drill for the drywall anchors
and drive the screws through the holes.
6. Align the switch horizontally, as illustrated in Figure 8..
Figure 8. Aligning an AT-FS716L for Wallmount Installation
1017
30
Publicidad
Tabla de contenido
