Assembly Of The Chassis; Assembly Of The Front Wheel; Assembly Of The Back Wheels - Emmaljunga NXT Challenge Manual De Instrucciones

Chassis

Assembly of the Chassis

1
1.1 Unfolding the chassis.
1.2 Unfold the handlebar until it stops in its top position
WARNING There must not be a child in the pram when it is folded or unfolded
WARNING Avoid having children in the vicinity when the pram is folded or unfolded
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury
1.3 Close the grey clip by turning it downwards
1.4 Check that the handlebar is locked in position
1.5 Repeat steps 1.3 -1.4 on opposite side
WARNING Always check that the handlebar is locked in position on both sides
1.6 Turn the handle into position by pushing both of the grey buttons on the outside of the handle. Make sure both
buttons clicks in position.
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury
1.7 Check that both the handle and the handle bar is locked in position
1.8 Fasten the safety leash as picture shows
1.9 WARNING! Strangulation Danger!
WARNING Always remopve safety leash when pram is not in use, otherwise the child may be at risk.
Store the safety leash in the pocket of the storagebasket (see Pic. 5.2)
WARNING Never leave your child unattended in the vicinity of the pram
2

Assembly of the Front wheel

2.1 Position the front wheel as the picture shows
2.2 Insert the shaft into the groove on the front of the pram
2.3 Lock the frontwheel by closing the quick release lever.
2.4 Rotate the quick release lever clockwise to tighten it further if needed
2.5 Close the quickrelease to lock it again
2.6 Check that the frontwheel is tensioned enough by lifting the chassis and pushing the wheel downwards.
Check that the wheel still can rotate around its axis
WARNING Always check that the wheel is firmly fixed and can not be pulled from the chassis
WARNING Avoid driving over sharp objects or surfaces eg. glass or the tyre can be punctured
WARNING To achieve optimum handling and to avoid punctures, air pressure should be correct.
Pleace check the air pressure at regular intervals (see marking on the tyre)
3

Assembly of the Back wheels

3.1 To mount the backwheel the shaft needs to be insert into hole (1) at the same time as the brake into hole (2)
3.2 Place the backwheel as in picture
3.3 To insert the brake in its hole, push the brakepart forward
3.4 Make sure that the shaft is positioned in line with the shaft hole
3.5 Push the button to insert the shaft into the hole and lock the wheel in position
3.6 Make sure the shaft has locked the wheel in position with a click
NXT Challenge v 1.1
37