Preparation Of Hot Water - Krups 897 Manual Del Usuario

We recommend turning the function selector
to before the first coffee and after the last
coffee of the day in order to quickly rinse the
system with the capsule holder empty to
prevent coffee particles sticking together (9).
Remove the capsule holder. Insert the
•
capsule upside down in the capsule holder
(11). Each capsule contains a single dose of
fresh coffee for a cup of espresso.
Replace the capsule holder (12).
•
Place the preheated cup (see the section on
•
"pre-heating cups") under the capsule
holder.
Your appliance is already pre-programmed for
the preparation of espresso (small cup, 50 ml)
or cappuccino (large cup, 120 ml). You can
choose whichever you want by pressing
either the key or the key
Once the espresso is finished, remove the
•
capsule holder and throw away the used
capsule (14).
After the preparation of espresso, the red
indicator light will flash until the optimum
operating temperature is. However, the
preparation of further espresso is possible at
any time.
To ensure that your next espresso is prepared
•
at the optimum temperature, replace the
empty capsule holder to retain its heat.
Individual Programming
To modify the pre-programmed quantities of
coffee, please proceed as follows:
Switch on the appliance, insert a capsule
•
into the capsule holder and place a cup
under it.
• As soon as the red operating light stops
flashing, press the memory key
• The -green control light will lit up as well
as the green indicator light for
(15).
• Press and hold down the
desired quantity of espresso has been
reached (16).
Now press the -key to memorise the
•
quantity (17).
16
ART. 897.PM6.5
To programme the quantity for a large cup,
•
just repeat this procedure using the

Preparation of Hot Water

With this appliance, you can prepare hot
water for liquids
Fill the water tank and turn the selector for
•
hot water/steam to the
• Switch on the appliance. As soon as the red
operating indicator light stops flashing,
swing out the steam and hot water nozzle
and place a suitable container under it.
• Press the
hot water/steam to the
you do not activate the selector within 2
minutes, the appliance will return to its
(13).
normal operating mode.
• As soon as there is sufficient water in the
container, return the selector to the
position.
emove the container and swing the steam/
• R
hot water nozzle inwards over the cup grid
so that any further drops of water can fall
into the drip tray.
Take care! The steam and hot water
nozzle is very hot.
Making steam
Steam makes the milk frothy for a cappuc-
cino, and also preheats cups or any kind of
liquid; the noise you hear during this
operation is caused by the intermittent
running of the water pump.
Please note :
Before making steam, make sure that the
. capsule holder on the machine is empty to
prevent the coffee becoming dried out and
blocking the hole in the coffee outlet.
and
key until the
Frothing milk for a cappuccino
You can make the milk frothy in order to whip
up a cappuccino. For best results, use the
16
position.
key and turn the selector for
position (18). If
18/02/04, 10:10
key. .