Krups 897 Manual Del Usuario página 17

accessory specially designed forthis purpose.
Fit it onto the steam nozzle (19).
Please note ! This accessory must only be
used for this purpose.
• Pour about 100 ml of skimmed milk into a
small high-sided container (maximum
capacity 0.5 L) which will fit beneath the
steam nozzle.
The container as well as the milk should be
chilled (do not rinse the container in hot water
before use).
First prepare an espresso, but only fill the
•
cup halfway.
• Turn the steam/hot water button to
press the key (20).
The red operating control light and the green
steam control light will both flash. As soon as
the red operating control light stops flashing,
the appliance has reached the optimum
temperature for the production of steam. If
you do not actuate the steam/hot water
button in the next 2 minutes, the appliance
will return to its normal operating mode.
Dip the steam nozzle into the container
•
holding the milk.
• During the preparation, keep the end of the
steam nozzle in the milk (21).
• Turn the steam/hot water button to the
position. The nozzle must not touch the
bottom of the container. Once the operation
is finished, return the button to the position
.
• Remove the container and swing the steam
nozzle towards the drip tray
Repeat the steam making operation for a
•
moment in order to eliminate the residue of
the milk which might remain in the end of
the nozzle. Remove the cappuccino
accessory to clean it. Wipe down the steam
nozzle with a damp cloth immediately after
the frothing.
Preheating cups
For the first espresso of the day, you should
pre-heat the cups with hot water. For further
use, the cups can be pre-heated on the
warming plate.
ART. 897.PM6.5
To pre-heat cups with water, proceed as if
making an espresso but without putting a
coffee capsule in the capsule holder.
Heating liquids
Turn the steam/hot water button
•
position and press the key
The red operating control light and the green
steam control light will both flash. As soon as
the red operating control light stops flashing,
the appliance has reached the optimum
temperature for the production of steam. If
and
you do not activate the steam/hot water
button within 2 minutes, the appliance will
return to its normal operating mode.
Immerse the steam nozzle and dip it into the
•
container holding the liquid. During this
operation, keep the end of the steam nozzle
in the liquid.
• Turn the steam/hot water button to the
position
Make sure that the nozzle does not touch the
bottom of the container.
• Once the operation is completed, return the
button to the
• Remove the container and swing the steam
nozzle towards the drip tray.
Important:
If you want to make espresso immediately
after making a cappuccino or heating liquid,
the appliacne must be allowed to cool down
to the coffee temperature. To do this :
Either place the capsule holder in position
.
without a capsule, put a container below the
coffee outlet and run about 2 cups of water
through via the coffee outler
or wait until the red operating control light
.
stops flashing.
Cleaning
Empty the water tank after each use.
•
• Never wash your espresso machine
accessories in the dishwasher.
17
to the
.
(22).
position.
18/02/04, 10:10
17