Morso 7370 Manual De Instalación página 7

On the rear of the stove, re-fit the two screws at the bottom to seal the holes that were
used to fix the heat screen.
Install the angle fixing using the two other screws that were used to fix the heat screen.
Remove 4 no. M6x25 screws and washers, and use two of these to fix the baseplate through
the rearmost holes.
The basic oven is lifted into place, so that
its sits on the bottom of the wall mounting.
Assemble the stove using the 2 no. M6x12
screws supplied at the top and the other two
M6x25 screws and washers which were pre-
viously removed at the bottom. (see sketch).
We recommended that 2 persons should
carry out this work.
7