Activating / Deactivating The Alarm; Alarm Sound; Turning The Alarm Sound Off; Clock Backlight - Oregon Scientific JMR868 Manual Del Usuario

ACTIVATING / DEACTIVATING THE ALARM

To activate or deactivate the alarm:
1. Press the ALARM button.
2. Press the or button. When the alarm icon
appears on the display, the alarm is activated.
When the alarm icon does not appear on the display,
the alarm is deactivated.

ALARM SOUND

When activated, the alarm icon flashes, the backlight
will come on for 8 seconds and a beeping noise starts
quietly. The alarm gradually becomes louder until it
crescendos at 2 minutes.

TURNING THE ALARM SOUND OFF

To turn the alarm sound off and automatically activate
it again after 24 hours, press any of the following
buttons:
MODE
ALARM
UP
DOWN

CLOCK BACKLIGHT

TO MANUALLY TURN THE BACKLIGHT ON

Press the LIGHT button on the clock, and the backlight
will turn on for 5 seconds.
TO ACTIVATE THE BACKLIGHT USING THE MOTION
/ LIGHT SENSOR
The clock backlight can be set up for a certain period
of time to turn on for 10 seconds when a movement
is detected in a dark room. Simply:
1. Press the ALARM button twice to get to the
Backlight Setting Display.
2. Press and hold the ALARM button for 2 seconds to
enter the Backlight Setting Mode.
3. The Code setting will flash.
4. Press the or buttons to change the setting.
(Make sure you select the Code setting that
matches the Code switch in the back of the

nightlight).

5. Confirm the entry by pressing the ALARM button.
6. The Motion Start Hour will flash.
7. Repeat (4) and (5).
8. Continue the above procedures to set the Motion
Stop Hour.
9. When the icon appears on the display, the
function is activated. When the icon does not
appear on the display, the function is deactivated.
NOTE Light ON – Press to turn the clock backlight
ON for 10 seconds remotely.
NOTE The nightlight Clock Control switch must be
set to On for this function to work.
TO ENABLE / DISABLE THE REMOTE-CONTROLLED
CLOCK BACKLIGHT
1. Press the ALARM button twice to reach the display
below.
2. Press the or buttons to change the setting to
either:
Enabled
NIGHTLIGHT
ACTIVATING THE NIGHTLIGHT USING THE MODE
BUTTON
The nightlight can be activated independently to the
clock unit. You can set the nightlight to the following
options:
1. Nightlight On - When the room is dark the nightlight
will stay on.
Slide the Mode button to On.
2. Nightlight Off - The nightlight stays off all the
time.
Slide the Mode button to Off.
3. Nightlight Auto - When the nightlight detects motion
in a dark room, it will light up for 20 seconds.
Slide the Mode button to Auto.
7
OR Disabled