English - Philips HI 994 Manual Del Usuario

English

Important
• Please read these instructions for use carefully in conjunction with the illustrations before
using the appliance.
• Never use the appliance if damaged in any way. Regularly check if the mains cord and the
supply hose are still in a good and safe condition.
If the mains cord of this appliance is damaged, it must only be replaced by Philips or their
service representative, as special tools and/or parts are required.
• Check if the voltage rating on the typeplate (under the steam tank) corresponds to the mains
voltage in your home.
• Only connect the appliance to an earthed mains wall socket.
• Never immerse the iron or the steam tank in water.
• Never fill the water tank with perfumes, vinegar, descaling agents or other chemicals.
• Take care that children cannot touch the iron when hot and that they cannot pull the mains
cord or supply hose.
• When leaving the iron, even for a short while, always remove the mains plug from the wall
socket and place the iron on the stand.
• Always place the steam tank on a stable flat and horizontal surface. Do not place the steam
tank on the soft part of the ironing board.
• Always place the iron on the iron stand. Do not place the hot iron on the steam tank, the
supply hose or the mains cord. The cordset should not be allowed to touch the soleplate
when it is hot.
• The appliance is equipped with an electric pump. This pump can be heard from time to time
when automatically refilling the boiler system. This is quite normal.
• The iron stand can become hot during use. If you want to move it, touch only the two lateral
edges of the stand.
General description
A
Removable water tank
B
Water tank cap filling opening
C
≥ Switch "Iron On/Off" with built-in pilot
light
D
≤ Switch "Steam tank On/Off" with built-in
pilot light.
E
U Pilot light "Steam tank heating-up".
(The pilot light goes out when the appliance is
ready for steam-ironing.)
F
* Pilot light "Water tank empty". (The pilot
light comes on when the water tank is empty
or not placed correctly into the appliance.)
G
0 "Jet of Steam" button (press)
H
U "Shot of Steam" button (press)
I
Steam control (rotate)
0 = dry ironing
3 = maximum steam
J
Steam activator (press-in for steam ironing)
K
Temperature dial (rotate)
L
Pilot light "Iron heating-up"
M
Supply hose with ball swivel
N
Storage compartment sliding door
O
Storage compartment for mains cord and
supply hose
(fig. 1)
P
Mains cord
Q
Soleplate
R
Iron stand (removable)
S
Steam tank
Making the appliance ready for use
- Before using the first time remove any sticker
or protective foil from the soleplate. Clean the
soleplate with a soft cloth.
- Fully unwind the mains cord and supply hose.
• Do not insert the mains plug into the wall
socket until the steam tank has been filled with
water.
- Place the steam tank on a stable flat surface.
- Place the iron on the iron stand.
4