Charge Indicator Lights; Using The Shark® Ion Robot; Buttons And Indicator Lights - Shark ION ROBOT RV750EU Instrucciones

CHARGING THE SHARK® ION ROBOT

CHARGE INDICATOR LIGHTS

In Use
Clean
Dock Max While
Charging
No Charge
or Off
• The blue charge indicator lights show how much charge is remaining.
• While the Robot is charging, all three blue LED lights will cycle. When charging is complete, all three blue
lights will illuminate steadily.
• If the Robot is idle and away from the charging dock for 10 minutes, it will enter Sleep Mode, and the
lights will turn off.
• If all the indicator lights are off, then the Robot is in Sleep Mode, the power switch is turned OFF (O) or
there is no charge remaining. Turn the power switch ON (I). Press any button to ensure the Robot is not
in Sleep Mode. If all indicator lights remain off, there is no charge. Place the Robot on the dock, leaving a
Full Charge Nearly Full
2cm space between the front of the Robot and the face of the dock. When the Robot is docked correctly
and begins to charge, it will beep and the charge indicator lights will cycle.
NOTE: If the low charge light is blinking red, there is not enough charge for the Robot to return to the
dock. Manually place the Robot on the dock, leaving a 2cm space between the front of the Robot and
Full Charge
the face of the dock.
Turn off the power switch if the Robot is not going to be used for a long period of time, this will help
preserve the battery.
USING THE SHARK® ION ROBOT
MANUAL CLEANING MODE
To manually start a cleaning cycle:
Step 1: Press the Clean button on the Robot.
Step 2: Press the Dock button to stop the Robot before it finishes
cleaning and automatically returns to the Base.
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your
Robot on a small section of the floor to ensure there is no scratching.
14
sha rkclean.eu
Low Charge Mid Charge Nearly Full Full Charge
Low Charge Mid Charge Nearly Full Full Charge
Mid Charge Low Charge
Nearly Full Mid Charge Low Charge
USING THE SHARK® ION ROBOT

BUTTONS AND INDICATOR LIGHTS

Clean
Dock Max
CLEAN BUTTON
Press to begin a long-running
cleaning session. Press again
to stop.
Clean
Dock Max
DOCK BUTTON
Press to stop cleaning and
send the Robot back to the
charging dock.
Clean
Dock Max
MAX MODE BUTTON
Press for more powerful
cleaning.
Clean
Dock Max
CHARGE INDICATOR
Displays the amount of
charge remaining in the
battery.
Clean
Dock Max
"!" ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
Clean
Dock Max
WI-FI INDICATOR
Blue light: connected to Wi-Fi.
Red light: not connected.
Flashing blue: Set-up mode.
Clean
No light: not set up yet.
Dock Max
s h a r kc l e a n . e u
15