Actions After The Heating Cycle; Cooling - Garant SG1 Manual De Uso

Automatic modes (SL, N, V, SC):
If the heating time is expected to be too short, extend the heating time using the Additional time
boost button.
Press the START/STOP button.
The heating cycle will start. The numeric display shows the remaining heating time in seconds.
The heating cycle is ended automatically.
If the shrink fitting is achieved before the end of the heating time (the tool can be moved), press the
START/STOP button to end the heating cycle, to avoid overheating.
Manual mode (MAN)
In this operating mode the heating is applied only as long as the START/STOP is pressed. The pre-selected
value is used for the heating power.
Press the START/STOP button.
As soon as shrink fitting is achieved (the tool can be moved), release the START/STOP button
immediately.

3.6.4 Actions after the heating cycle

Removing the tool
Remove the tool from the chuck with a gentle pull upwards by hand.
After removal, place the tool on a heat-resistant surface and ensure,
that personnel in the vicinity are protected from accidentally touching the tool and the hot chuck.

3.6.5 Cooling

After each heating cycle: Cool the chuck down!
Place the chuck in the contact cooler that is ready for it, and cool it sufficiently.
Note: The longer you wait before placing the cooling adapter on it, the more heat will dissipate into
the mounting area of the chuck and into the tool.
When placing the cooling adapter on the chuck, take care not to damage the tool!
Optional SKE1 spray cooling unit:
 For contour-independent
cooling of shrink-fit holders
 Maximum tool length = 400 mm
 Switched on using the spray cooler button on the
GARANT shrink-fitting unit
 Tank with pump can be stored in the subframe
cupboard No. 35 4290:
Fig. 11: Use of the cooling insert in a free contact cooler.
www.hoff mann-group.com
DE DE
EN
FR FR
IT IT
ES ES
CZ CZ
PL PL
RU RU
ZH ZH
45