Maintenance - Dexter 1500RH2-50.5 Instrucciones Legales Y De Seguridad

6. OPERATION
Switching on: Press
In low temperatures, the machine reaches its full hammer/impact performance only after running for a certain period of time.
This start-up time can be shortened by striking the drill/chisel against the floor once.
Speed control: Press the switch by slight or heavy strength to control the ratation speed from minimum to maximum.
Overload Clutch
If the drill becomes caught or jammed, the drive to the drill spindle is interrupted.
loosen the drilling tool. Using a machine that has a jammed drilling tool can result in
strong torques!

7. MAINTENANCE

After use, check the tool to make sure that it is in top condition.
It is recommended that you take this tool to an Authorized Service Centre for a thorough cleaning and lubrication at least once a
year.
If the power cord is damaged, it must be replaced by the manufacturer, its service agent
order to avoid a safety hazard.
If the carbon brushes need to be replaced, have this done by a qualified repair technician (always replace both brushes at the same
time).
If you want to change the grease when the machine has been used after 24 hour, you can use the wrench to remove the oil cap
and replace it accordingly, but the grease cup is not included with the tool,you could find the universal lithium grease and fill
around 30g into the machine.
WARNING ! To ensure safety and reliability, all repairs should be performed
by an AUTHORIZED SERVICE CENTRE or other QUALIFIED SERVICE
ORGANIZATION. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
it down
120
FR
ES
PT
IT
EL
PL
UA
RO
EN