Publicidad
STEP 1
Remove inner member from slide.
Push the outer member of slide
out until fully extended, press
black release lever found in the
middle of the slide, and firmly pull
slide completely away from the
inner member (See Figure B).
Repeat for the other side.
STEP 2
Install rear brackets to the outer
member of the slides that you just
removed. Make sure the bend is
facing the inside of the slide
(See Figure C).
STEP 3
Decide the orientation of the frame
and attach inner member of slides
using the spacers and #8-32 x 5/8"
flat head machine screws
(See Figure D).
Repeat for the other side.
Note: Door mount bracket
must be mounted to the front
of unit depending on preferred
orientation (waste bins to the
right shown).
#2
STEP 4
Drill a 1\16" x 1\2" deep hole 12"
from the cabinet floor and 3\8"
from front of cabinet and install
the front of the outer slide with
the supplied #8 x 5/8" truss head
screw (See Figure E).
Repeat for the other side.
1
3
3
16
32
8
#2
#2
1
5
16
#2
#1
16
2
#2
3
1
8
2
Install spacer location first
FIG. E-1
#2
#2
1
1
4
8
7
1
4
64
#2
3
3
7
5
8
32
64
8
5
5
#1
16
8
FIG. B
FIG. C
FIG. D
Spacer location
1
12"
8
800-626-1126 | rev-a-shelf.com
Release Lever
DMB facing outward
FIG. E-2
1/16" x 1/2" deep
3/8"
Publicidad
